2020. 3. 22. 19:13ㆍ카테고리 없음
Ote: 'If any further compenents are found please repeat the above process until you receive the message 'Found new hardware:Your hardware is installed and configured use' You will now need to check that The drivers are installed correctly. Right Click on My Computer and Left Click on Properties.Click on Hardware tab and then Device Manager. In the 'Device Manager',click on the '+symbol' on the 'Sound Video and Game controllers' section.If the driver is installed correctly you should see the ' SMI Grabber Device '. If it has a Yellow mark next to it then this means that the driver is not installed correctly. You will need to remove the driver and disconnect the Video001 Wireless Camera Receiver (or Video002 USB 2.0 DVR) from the computer and re-connect is to install the driver again. Software Installation To start the Application Installation click Start/Run then type your CD-ROM and click 'Install'. Select your language for the installation and click 'next' or/ and 'install'.
Click 'finish' to complete setup, restart your computer if needed. N 3 Run MultiViewer which you just installed. Instruction of remote controller (Video001) Note:The remote controller only work for control the hardware device,not for the application of this device.Please not do use channel auto-view function with both application and remote control at the same time. Key functions Power on /off:only works for when using power adaptor. CH1-CH4: to select the 1-4 channel on. Auto:stop/start channel auto-view,automatically select CH1-CH2-CH3-CH4,then CH1. The default speed is 1 time/second (you can also change the speed with using 'CH1-CH4', for example,when you click 'CH1' then click 'Auto' the speed will be 1 time/second and so on.
Video001 Software
Set:IF you do not want to any channels(s).
How can this be resolved. Serial number for any video converter professional? Step 4 The wireless camera receiver will be positioned next to the television. What would you like to ask? Are you a Computer and Internet Expert? The location of your cameras should be close to power outlets.
Tilt the camera if needed to get the view you desire.